Owner's Manual

LOADING
To load any Hunting Master series of air gun, the cylinder magazine must first be
removed from the gun. Loading is accomplished easily by following these steps:
1) Hold the rifle or pistol in your left hand with the muzzle pointing in a safe
direction. Make sure the hammer is in the lowered, uncocked position with
the hammer safety on and with the primary trigger safety in the safe "S"
position.
2) Grasp the magazine firmly between your right thumb and index finger. Push the
magazine straight out to the right to clear the receiver using the force of your
thumb (see Figure 3).
3) Place six appropriate caliber pellets skirt first into the front of the cylinder
magazine. The front of the magazine is noted as the fluted end of the cylinder
(see Figure 4)
4) The pellets must be pushed back so that the heads are flush with the front
cylinder face. For loading the Hunting Master R/S, please consult the special
instructions below.
5) Once loaded, the magazine is reinserted into the receiver from the right side
until it clicks positively back into position. Indexing is automatic and requires
no further alignment. The gun is now ready for firing six repeat shots.