Instruction Manual
Make sure the rie is unloaded by removing the magazine and ensure there
are no pellets in the breech. Put the gun on SAFE.
Invert the rie and secure it in a rie stand or
similar stabilizing device. Remove the
stock.
First-stage adjustment
The adjustment screw for the rst stage is situated
in the section underneath the trigger blade. Using
a 1.5mm Allen key, turn the screw clockwise to
decrease the amount of rst-stage travel. Turn the
screw counterclockwise to increase the amount
of rst-stage travel.
Second-stage and sear adjustment
This adjustment screw is situated in the sear
bar. Using a 1.5mm Allen key, turn the screw
clockwise to decrease the amount of second-
stage travel and sear engagement. Turn the screw
counterclockwise to increase the amount of
second-stage travel and sear engagement.
NOTE: This adjustment affects sear engagement.
It may be necessary to alter both adjustments to
achieve the desired setting. Adjustment of one
screw may affect other settings. Do not over-
adjust, as this may cause the gun to re prematurely or not operate correctly
and make the rie unsafe. Always check your settings to ensure correct and safe
operation of the rie. Always ensure that operation of the safety is unaffected by any
alterations you may make to the trigger mechanism.
Trigger blade position
To change the position of the trigger blade, undo the 2.5mm Allen headed bolt that
secures the trigger blade, and move it to a position of your choice.
Adjusting the trigger
Keep your nger off the trigger while cocking the air rie.
WARNING:
6