Instruction Manual
Filling the rie
1) Attach the stainless steel ll adapter to the correct ll equipment. Rotate the ll port’s
protective cover to allow access. Insert the ll adapter into the ll port. Do not use any
other type of adapter other than the one supplied with the rie. Slowly ll the rie to a
MAXIMUM of 200 bar (approximately 2,900 psi) pressure. Filling the rie too fast is
unsafe and creates excess heat that may result in a low or inaccurate ll pressure. Do not
overll as this will damage the gun and result in low power. Such damage is not
covered under warranty.
2) When charging is complete, bleed the excess air using the ll apparatus bleed screw and
remove the ll adapter from the rie. When nished, rotate the protective cover to prevent
contamination of the ll port.
WARNING:
4
Use only compressed air in this airgun. Use no other gases—including oxygen,
which can cause a re or explosion that may result in serious injury or death.
Disconnecting the ll hose from the airgun without bleeding the air rst may
result in injury from hose whip as a result of pressure in the ll hose.
Do not attempt to repair the airgun or to disassemble to correct an over ll or
valve lock. Parts can y from the airgun at dangerous speeds when it is disassem-
bled while pressurized.