Instruction Manual
Filling the rie
Attach the stainless steel ll adapter to the correct ll
equipment. Remove the ll port’s protective cover to
allow access. Insert the ll adapter into the ll port.
Do not use any other type of adapter other than the
one supplied with the rie. Slowly ll the rie to a
MAXIMUM of 200 bar (approximately 2,900 psi)
pressure. Filling the rie too fast is unsafe and creates
excess heat that may result in a low or inaccurate ll
pressure. Do not overll, as this will damage the
gun and result in low power. Such damage is
not covered under warranty.
When charging is complete, bleed the excess air using the ll device bleed screw and
remove the ll adapter from the rie. When nished, replace the protective cover to prevent
contamination of the ll port.
Occasionally, lightly lubricate the probe o-rings with diver's silicone grease.
WARNING:
3
Use only compressed air in this airgun. Use no other gases—including oxygen, which can
cause a re or explosion that may result in serious injury or death.
Disconnecting the ll hose from the airgun without bleeding the air rst may result in
injury from hose whip as a result of pressure in the ll hose.
Do not attempt to repair the airgun or to disassemble to correct an over ll or valve lock.
Parts can y from the airgun at dangerous speeds when it is disassembled while pressurized.
To load the magazine, insert pellets skirt rst into the recessed
side of the 6-shot rotary mag until the skirt of the pellet lies
ush with or below the surface of the magazine. Repeat until
all 6 chambers are loaded.
The mag can now be inserted back into the gun. Engage the
safety by pushing the safety catch lever rearward.
To re the rie, disengage the safety by pushing the safety catch lever forward to the F
position. When safe to do so, take aim, cock the hammer by pulling it all the way back and
squeeze the trigger.
Loading the rie