DC40 Drawer Fridge EvaKool 16 Enterprise Street CALOUNDRA QLD 4551 Tel: 07 5492 7777 www.evakool.com Please read this manual carefully before using your unit.
Key Product Features: Powered by 12 Volt DC Compressor. Reliable electronics, high efficiency, low energy consumption. Built-in drawer compartment 1. Safety Instructions Warning: Do not use your unit if any cabling is damaged, frayed or exposed. Warning: Do not attempt or continue to operate your unit if it is wet. When using the unit ensure the circuit being used has a fuse or circuit breaker, recommended size for DC 12 Volt is 15 Amp, DC 24 Volt is 7.5 Amp. 2.
Cable Thickness 12V Max Cable Length 24V Max Cable Length [mm2] AWG [m] [ft.] [m] [ft.] 2.5 14 2.5 8 5 16 4 12 4 13 8 26 6 10 6 20 12 39 10 8 10 33 20 66 LED Control Panel FAULT INDICATOR ON/OFF SWITCH TEMPERATURE CONTROLS LED DISPLAY M / TURBO SWITCH TURBO INDICATOR Temperature setting range： -16ºC to 10ºC. Plug in the DC power cable. Press ON/OFF button to turn on unit.
. Cleaning and maintenance Clean the appliance inside and out with a clean damp cloth every week. If it is dirty, use sodium bicarbonate dissolved in lukewarm water to clean the unit. Never use abrasive products, detergents or soap. After cleaning, wipe out with a clean damp cloth and dry carefully. Do not store product inside unit if the unit is not on Do not store the unit if it is wet inside or without leaving the lid open. Never clean the unit under running water or in dish water.
Yellow fault light flashing 1 Flash every 4 seconds: Low Voltage * Try on different power source (vehicle or 240V AC power). If changing power source fixed issue, then possible issue with original power source. * Ensure cabling between fridge and battery is at least 4mm, if the distance is more than 2 meters then use at least 6mm cable. 2 Flashes every 4 seconds: Fan Issue Fan is drawing too many amps (over 0.5 amps), replace fan.
. Installation Instructions: a. Remove the mounting frame from the fridge. b. Locate the mounting frame into the position you wish to install the fridge. c. Use the screws provided to fix the mounting frame to the base. Mounting Frame d. Insert the drawer fridge onto the mounting frame. Ensure the locating lugs are securely inserted into the locating slots.
e. Using the 4 screws provided, secure the fridge to the mounting frame as shown below. 7.
