Data Sheet

Frequency Response:
12000 Portland Avenue South, Burnsville, MN 55337
Phone:[phone], Fax:[phone]
www.electrovoice.com
© Telex Communications, Inc. 6/2006
Part Number 534681 Rev C
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: [phone]
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/553-5992 or 402/467-5321
For technical assistance, contact Technical Support at: 800/392-3497 or 952/736-4656
Specifications subject to change without notice.
Wiring Diagram:
Dimension Drawing:
Architects’ and Engineers’ Specifications:
The microphone shall be a shock-mounted, omnidirectional, dynamic type with wide-range response uniform from 80 to
13,000 Hz. The microphone shall employ a high-mass acoustic chamber, integral with the transducer assembly that shall
be shock-isolated within an external aluminum case. The microphone shall have an internal pop blast filter to prevent dust
and magnetic particles from reaching the diaphragm. The impedance shall be such that the microphone will match 50-,
150- and 250- ohm inputs. The line shall be balanced to ground and phased. The output level shall be 2.2mV/pascal. The
magnetic circuit shall be nonwelded and employ a neodymium alloy magnet. The inner case shall be made of steel and the
outer case of machined aluminum. The microphone shall have a maximum diameter of 49 mm (1.94 in.) and a length of 197
mm (7.75 in.). Shank diameter shall be 25 mm (1.0 in.) . Weight shall be 269 g (9.5 oz). Finish shall be nonreflecting semi-
gloss black. The microphone shall have a built-in, 3-pin, XLR-type connector, and shall include a 5/8-in. -27-thread stand
coupler and a zippered vinyl carrying pouch. The Electro-Voice RE50N/D-B is specified.