Data Sheet

Electro-Voice | RE3-ACC-CXUF Rear to front mount antenna
cable kit
RE3-ACC-CXUF Rear to
front mount antenna
cable kit
▪ Two high-quality RG-58 50
Ω coax cables
▪ Female flange mount BNC on one end for panel
mounting
▪ Male BNC on other end couples to receiver antenna
input jack
The CXUF is a pair of high quality, low-loss coax cables
intended to relocate a wireless receiver’s antenna
input jacks to the front panel of a 19” rack. The
threaded flange mount connectors fit securely into the
openings of either the RMK1 or RMK2 rack mounting
kits for front-mounting the stock ½ wave antennas or
extension coax cables. The male BNC twist-on
connectors on the other ends securely connect to the
receiver’s antenna A and antenna B RF input jacks.
Technical specifications
Cable type: Coaxial
Impedance:
50 Ω
Length: 1 meter
Connector types: Male BNC twist-on on one end
Female BNC threaded flange mount
on the other end
Color:
Black
Net weight: 2 oz. (57 g)
Gross weight:
2.1 oz. (61 g)
Installation/configuration notes
To install the antenna cables, do the following:
1.
Ensure the receiver is securely mounted with RMK1
or RMK2 rack kit.
2. Remove the locking nut, lock washer, and rubber
insulator from the CXUF threaded flange-mount
connector.
3. While aligning the flat (A) portion of the threaded
connector barrel with the flat portion of the rack ear
front flange opening, slide the threaded barrel
through the opening until it is fully extended through
the rack ear flange. (RMK2 rack ear used for
illustration.)
FLAT (A)
CXUF
Using RMK2 as example
4. Slide the rubber insulator ring onto the threaded
connector barrel.
5.
Slide the lock washer onto the threaded connector
barrel.