User's Manual

75
Figura 5
SmartKey Configuration Central: server configuration
Figure
Figura 5
shows the SCC panels used for the configuration of the Smartkey server. To configure the service
version set the protocol you want to use and press Apply. The Smartkey service will be automatically installed and
started. The service will also start automatically at each system reboot.
For the Executable version set the protocol you want to use and press Apply. Then press Start to run the Executable
Server. You can add the file
askeysrv.exe
into the Windows Programs-Startup menu to force the automatic
execution of the Executable Server.
These are the options available for the configuration:
• TCPIP: enables the TCPIP protocol.
• TCPIP Port: number of the port (TCP) used for the TCPIP protocol.
•
ANP: enables the ANP protocol.
•
ANP Dir: directory used by the ANP protocol for exchanging files.
•
Timeout: timeout in seconds before a non-replying client is disconnected and its license is released. This is
very useful in case of network troubles.
•
Autohide: automatically closes the Executable Server's window after the start.
•
Monitor: starts the server Monitor used to check available licences and client connections.
15.2 Configuration of client
The computer on which the program operates can be configured through the Multilan Client window of SCC The
central table lists all the protocols on which the protected program has to search the SmartKey. Figure 6 shows an
example where the client was configured so that the Windows programs search the SmartKey on computer
187.11.10.74, port 16567, and among SmartKeys installed on local ports.