Troubleshooting guide

OmniTouch UC R3.0 – Troubleshooting Guide for IP Softphone

Edition 3 – Page 24

2.3.10 Checking the Nomadic gateway

In above screenshot, a call has been launched from the 4980 in Nomadic VoIP mode. After a few

seconds, the 4980 is frozen and the only way to exit from this state is to kill the 4980 binary through

the Task Manager.

This trouble appears because the Nomadic gateway has not been configured on OmniTouch UC

side. To solve this problem, use the Web Administration tool and indicate the IP address of the

INTIP/GD board, as indicated below: