Instruction manual

Instruction Manual PCD 650
81
4.2.6 System Settings – Page 6
Figure 73 : System Settings - Page 6
This page allows you to clear the memory and reset the meter to factory defaults.
Parameter Description Factory Default
Clear logged
Data Memory
YES – Select this to clear all the stored data from the
meter’s memory
NO – Select this if you do not wish to clear the stored
data from the meter’s memory
NO
Factory Reset
YES – Select this if you wish to reset the meter to its
factory default settings. This includes:
 Deleting your calibration data
 Resetting setup parameters to factory defaults
(except date & time)
 Deleting your stored data in the memory
NO – Select this if you do not wish to reset the meter.
When ‘YES’ is selected and confirmed by pressing
ENETR key, the meter is reset to factory defaults and
then the meter goes to measurement mode.
NO
I
mportant:
1. Please memorize the password that you have entered after enabling the
password protection because without entering password, neither you can
disable the password protection or reset the meter to factory defaults.
However, if the user forgets his password, he can contact the
nearest distributor or Eutech Instruments/Oakton Instruments to
request for meter password. This would be unique to each instrument
and would be tied to the serial number of the unit.
2. Default password ‘88888’ is valid only if it is not changed with new
password.
3. You can enter ‘00000’ (read-only password) if you wish to view the setup
parameters. You are not allowed to modify any parameter when you
enter ‘read-onl
y
password’.