Instruction manual

Instruction Manual PCD 650
33
10. To stop data transfer, click Disconnect button.
11. To clear the transferred readings from the screen, select the desired row
and click Clear Data button.
2.13.2 Sending a single reading from single measurement mode
1. Make sure that the CURRENT DATA SET parameter is set to ‘SINGLE’ in the
System Setup (Refer ‘System Settings – Page 4’ on page 79).
2. Make sure the CyberComm 600 application is up and running (page 12).
3. Make sure the IrDA port of the meter is closer and in-line with IrDA port of
the computer.
4. From Single measurement mode, press PRIN (F3) to send data to
CyberComm.
5. In CyberComm screen, press Find Device button. CyberComm starts
finding the meter.
6. When CyberComm finds the meter, press Connect button. The IrDA link is
established. The currently displayed measurement reading is transferred to
CyberComm. (Figure 32)
7. Once the data transfer is completed, the IrDA link is disconnected
automatically.
8. To send another reading, repeat step 3, 4, 5 & 6.
9. To clear the transferred readings from the screen, click Disconnect button
and click Clear Data button.
Figure 32 : Transferring a single measurement data