Instruction manual

Instruction Manual PCD 650

4.11 O

mg/L (ppm) – DO Concentration Setup

DO Concentration

(mg/L) setup screen present many options to control the operating

parameters, which can be controlled and set from the DO setup screen. The settings

are displayed in 2 pages. Press NEXT-P (F2) and PREV-P (F1) to navigate through

these pages.

4.11.1 DO (mg/L) – Page 1

Figure 88 : DO (mg/L) – Page 1

This page allows you to set operating parameters for the DO Concentration

measurement mode:

Parameter Function Factory

Default

Select DO Unit

Sets the unit of measurement for DO

Available units: mg/L and ppm

mg/L

Auto Salinity Comp

DISABLE – No automatic compensate

ENABLE – The meter will apply measured salinity for DO

concentration of your sample.

Note: This option is activated only in CD650 & PCD650.

DISABLE

Set Salinity

Allows to set the salinity (in ppt) for your solution

Available range: 0 to 50 ppt

0.0 ppt

NOTE: Auto salinity compensation will be applicable only in multi measurement

mode and only if one of the measurement selected is conductivity related. Otherwise,

manually set salinity value will be applied.