User Guide

Instruction Manual CON 400/410
- 15 -
5 MEASUREMENT
This meter is capable of taking measurements with automatic or manual temperature
compensation. Factory default is set with automatic temperature compensation (ATC) on.
5.1 Automatic Temperature Compensation
For automatic temperature compensation (ATC) simply
plug the conductivity/TDS probe into the meter (see page
6 for directions). The ATC indicator will light on the LCD.
NOTE: If the ATC indicator does not light, manual
temperature compensation may be selected in
the meter’s SETUP mode. See Program P4.3 on
page 32 for directions on selecting Automatic
Temperature Compensation.
Figure 11 - ATC annunciator will
light up when connected to
temperature probe