User Guide

Instruction Manual CON 400/410
- 14 -
Figure 9 - TDS Conversion Factor
From measurement mode
1. Press Setup key to enter Set Up mode.
2. Press the S and T keys to scroll through subgroups
until you view parameter P4.0.
See Figure 9.
3. Press the ENTER key again. The upper display shows
a value and the lower display shows “tdS”.
4. Calculate the TDS factor of your solution. See
Addendum 2 on page 46 for information on how to
calculate the TDS factor.
5. Press the S and T keys to select your calculated TDS
conversion factor.
6. Press the ENTER key to confirm selection and to
return to the subgroup menu. Press the CAL/MEAS
key to return to measurement mode.
ppt
ppm
SETUP
p 4.4
ppt
ppm
SETUP
0.50
M
R
M
I
E
N
T
E
R
R
A
N
G
E
SETUP
cof
p 4.0
M
R
M
I