User Guide

Instruction Manual pH 510/ Ion 510
5
2.5 Connecting the Electrode Holder (Optional)
The integral electrode holder serves as a handy holder
for mounting a few pH/Ion electrodes or a temperature
probe during measurement or when idle.
This meter’s base plate has a side metal bar to which
you can attach an integral swivel electrode holder.
You can mount the electrode holder on either right or
left side of the meter.
To position the electrode arm:
Use a Phillips screwdriver to remove the screw holding
the electrode holder. Slide the side metal bar until the
second screw slot lines up with the original screw
hole. Use the screw removed earlier to secure the
electrode holder into position.
NOTE: The side metal bar is reversible. If desired,
remove screw holding electrode holder base and slide
out of brackets, Slide base into brackets on opposite
side and tighten screw.
Body of
Electrode
Holder
Bottom of Mete
r
To install the electrode arm to the meter:
To mount the electrode arm into the metal rod on
the side bar, align the slot with the metal rod and
base of electrode arm. Push it downwards until it
fully sits into position. Avoid using excessive force
when fixing or removing. The electrode arm is
ready for use.
NOTE: Move the base of the electrode holder if
you wish to swing the electrode holder about. To
prevent the meter from toppling over causing
accidental spills, DO NOT swing the body of the
electrode holder.
Side Metal
Bar
Base of
Electrode
Holder