User Guide

35
9.4.2 P4.1 : Parity
Parity check allows the unit to monitor the integrity of
the data that it transmits. To accommodate for the
variances in standards used, three different parity
checks have been provided in the table below. The
default parity is even (2).
Value Parity
0No Parity
1 Odd Parity
2 Even Parity (Default)
9.4.3 P4.2 : Stop Bit
The Stop Bit allows the selection of the appropriate
stop bit when transmitting to other peripheral devices
(such as printers). You can select the Stop Bit to be 1
or 2 depending upon the model and make of peripheral
device (The instruction manual of peripheral device
should indicate the stop bit used). Under default
conditions the stop bit is 1 (one).
Figure 37: P4.1 Setting Parity Value
Figure 38: P4.2 Setting Stop Bit
value