User Guide
34
9.4 Program 4 – Communication Setup
This program allows you to set up the instrument’s
communication parameters of the CyberScan 100 to
enable proper communication with the printer or
computer of choice.
9.4.1 P4.0: Baud Rate
You can select a baud rate either at 2.4, 4.8, 9.6 or 19.2
Kbps. Under default conditions, the baud rate is set to 9.6
Kbps.
1. From pH or mV measurement mode, press SETUP
key.
2. Press CON key (10 times) until P4.0.
3. Use MI/
!
or MR/
"
key to change different baud
rate.
4. Press CON key to confirm and continue to set Parity
in P4.1.
See Figure 36.
NOTE:
To exit without confirming baud rate value, press
CAL/MEAS key. This will bring you back to the
measurement mode.
Figure 36: P4.0 Setting Baud
Rate