Instruction manual

3.2 Connecting the probe

The Eutech Instruments Standard/Waterproof PC 10 meter uses a specialty combination pH /

Conductivity / Temperature probe. The probe cable has a notched 6-pin connector to attach

the probe to the meter.

NOTE: Do not substitute other probes or electrodes. For replacement probe, see

the “Accessories” section, pages 23 - 24.

NOTE: Keep connector dry and clean. Do not touch connector with soiled hands.

To connect the pH / Conductivity probe:

1. Line up the notch and 6 pins on the probe connector with the holes in the connector

located on the top of the meter. Push down and screw the metal sleeve to lock the

probe connector into place. See Figure 6.

2. To remove probe, unscrew the metal sleeve and slide up the probe connector. While

holding onto metal sleeve, pull probe away from the meter.

CAUTION: Do not pull on the probe cord or the probe wires might disconnect.

Standard PC 10 Waterproof PC 10

ure 6 - Probe Connector