User Guide

Instruction Manual CyberScan CON 1500
21
4.2.6 Setup Page 5.0: Set the Single/Multi Point
Calibration mode (SPCAL for all modes)
This setup page allows you to select a single-point or a multi-point
calibration. This option is applicable during all modes of
measurement (Conductivity, Resistivity and Total Dissolved Solids).
1. Access the Set the Single/Multi Point Calibration Mode (SPCAL)
setup page by pressing setup during measurement mode
screen.
2. Use the ▲/save or ▼/view keys to scroll until the screen
displays the page as shown below.
)
This page will be displayed only if setup is entered from Resistivity or
TDS measurement mode. However, when setup is entered from the
conductivity measurement mode, this page is not accessible. You
need to enter the Set the Auto Calibration Mode (ACAL) setup page
first and then press the enter key to directly access the Set the
Single/Multi Point Calibration Mode (SPCAL) setup page as in step 3 .
save

view



 press to set value
press to accept
enter