Instruction manual

Instruction Manual PC 510

7 HOLD FUNCTION

This feature lets you freeze the display for a delayed observation. HOLD can be used any time in

MEAS mode.

1. To hold a measurement, press the HOLD key while in measurement mode. “HOLD” will appear on

the display.

2. To release the held value, press the HOLD key again. Continue to take measurements

MEAS

HOLD

READY

ATC

°C

678

20.7

NOTE

• If the meter is shut off manually, the HOLD value will be lost.

• Your meter has an auto endpoint feature. When this feature is switched on, and when a

reading is stable for more than 5 seconds, the display will automatically “HOLD” the

reading. The “HOLD” indicator appears. Press the HOLD key to release the reading. To

switch on or off the auto endpoint feature, see SETUP Program P3.1 on page 28 for pH

and SETUP Program P7.1 on page 34 for conductivity/TDS.

8 ADVANCED SETUP FUNCTIONS

The advanced setup mode lets you customise your meter’s preferences and defaults. The PC 510

bench meter features different sub-groups that organise setup parameters.

The sub-groups are:

For pH For Conductivity & TDS

P1.0 View calibration data (CAL) P5.0 View calibration data (CAL)

P2.0 View electrode data (ELE) P6.0 View electrode data (ELE)

P3.0 Unit Configuration (COF) P7.0 Unit Configuration (COF)

P4.0 Reset to factory default

settings (rSt)

P8.0 Temperature (tPr)

P9.0 Reset to factory default settings

(rSt)

ure 23: HOLD function