User Guide

11
CyberScan CON 200 25-pin connector
2 (TxD) --------------------------------------- (RxD) 3
4 (DSR) -------------------------------------- (DTR) 20
5 (GND) -------------------------------------- (GND) 7
7 (CTS) --------------------------------------- (RTS) 4
Refer to Figure 11 for the pin number position.
5432 1
987 6
The meter uses hardware handshake i.e. the meter expects both DSR and CTS lines to be
active before it sends data. If the
key is pressed while the printer is not ready or if the
printer is off, the meter displays error by blinking the printer and the ERR annunciators
alternately, and waits for the printer to be ready. While the meter is displaying printer error, the
user may press the CAL/MEAS key to return to the measurement (MEAS) mode.
Fi
g
ure 11: Pin number
p
osition of the 9-
p
in RS 232
p
ort
Fi
g
ure 12: Error in
p
rintin
g