Instruction manual

Instruction Manual CyberScan CON 1500
22
save

view

3. Press the enter key to go into the Set the Single/Multi Point
Calibration Mode (SPCAL) setup page.
4. Use the ▲/save or ▼/view keys to select the options of YES
(single-point) or NO (multi-point) so as to configure the
Calibration Mode to Single-point Calibration or Multi-point
Calibration mode.
5. Press the enter key to confirm selection OR press std to exit
from this page.
6. Continue to access other setup pages using ▲/save or ▼/view
keys OR press std key to exit from the setup and return to
measurement mode.
.