Instruction manual
20
MEAS
P
H
O
C
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
ENTER
ENT
SETU P
HOLD
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
cur.1
SETUP
HOLD
cur.2
SETUP
HOLD
SETUP
HOLD
SETUP
HOLD
Temperature settings
see section 6.3
Relay A (set point 1) settings
see section 6.4
Relay B (set point 2) settings
see section 6.4
Controller settings
see section 6.5
Current output 1 settings
see section 6.6
Current output 2 settings
see section 6.7
Wash contact settings
see section 6.8
Unit settings
see section 6.9
Calibration
see section 5
CAL
6 SET-UP MODE
6.1 Enter Setup mode
In the Setup mode the controller can be configured to your individual
requirements.
1. While in Measurement mode press the ENT key.
2. The display prompts you to enter the security
code. Set the security code with ▲ or ▼ key to:
–“SCD22” if you want to change parameter settings
–“SCD000” if you want to view only parameter settings (view
only mode)
3. Press the ENT key.
Note: to exit Setup mode at any time press the ▲ and ▼ key
simultaneously (escape). The controller returns to the Measurement mode.