User Guide

TABLE OF CONTENTS
1
INTRODUCTION...................................................................................1
2 PREPARATION ....................................................................................2
2.1 POWER SUPPLY REQUIREMENTS (SL2 POSITION)........................................... 3
2.2 CONNECTING THE ELECTRODE AND TEMPERATURE SENSOR (SL1 POSITION).... 3
2.2.1 To connect the Conductivity electrode: .............................................3
2.2.2 To connect ATC temperature sensor: ...............................................4
3 INSTALLATION ....................................................................................5
3.1 MECHANICAL DIMENSIONS ............................................................................ 5
3.2 WALL MOUNT.............................................................................................. 5
3.3 PANEL MOUNT ............................................................................................ 6
4 DISPLAY AND KEYPAD FUNCTIONS................................................7
4.1 DISPLAY ..................................................................................................... 7
4.2 KEYPAD ......................................................................................................8
5 CALIBRATION......................................................................................9
5.1 IMPORTANT INFORMATION ON TRANSMITTER CALIBRATION ...............................9
5.2 TEMPERATURE CALIBRATION ...................................................................... 11
5.3 CONDUCTIVITY CALIBRATION ...................................................................... 12
6 ADVANCED SETUP FUNCTIONS.....................................................13
6.1 RANGE AND ZOOMING SELECTION SETTING.................................................. 13
6.2 TEMPERATURE COMPENSATION SETTING .....................................................15
6.2.1 Automatic Temperature Compensation ..........................................15
6.2.2 Manual Temperature Compensation...............................................16
6.3 HOLD CURRENT SETTING.......................................................................... 18
6.4 OUT-OF-RANGE CURRENT SETTING ............................................................ 18
6.5 TEMPERATURE COEFFICIENT AND NORMALIZATION TEMPERATURE SETTING .... 19
6.5.1 Setting the temperature coefficient .................................................19
6.5.2 Setting the normalization temperature ............................................19
6.6 CELL CONSTANT SETTING .......................................................................... 20
6.7 LINE RESISTANCE SETTING ......................................................................... 20
6.8 VIEWING CALIBRATION POINT...................................................................... 21
6.9 VIEWING THE ELECTRODE DATA.................................................................. 21
6.10 RESET FUNCTION ...................................................................................... 22
7 FACTORY DEFAULT SETTINGS ......................................................23
8 TROUBLE SHOOTING GUIDE...........................................................24