Instruction manual

Instruction Manual αlpha CON 2000

6.10 Configuration (CNFG) sub-function

In this sub-function you configure the transmitter to suit your requirements.

SETUP

HOLD

ENT

SETUP

SETUP SETUP

HOLD HOLD HOLD

444

ENT

ENT ENT

ENT

SETUP SETUP

HOLD HOLD

4 4

SETUP

HOLD

SETUP

MEAS

µS

°C

ATC

HOLD HOLD

ENT

SETUP SETUP

HOLD

4 4

1. Select the “CNFG” subfunction, then press the ENT key.

2. Enabling/disabling the display backlight: press the ▲ or ▼ key to switch display

backlight on (BKLT ON) or off (BKLT OFF). Press the ENT key to confirm your selection.

3. Setting the backlight intensity (appears only If backlight is on): press the ▲ or ▼ key

to set backlight intensity (setting range: minimum 1 to maximum 4). Press the ENT key to

confirm your setting.

4. Selecting the cell type: press the ▲ or ▼ key to select “2-cell” or “4-cell” type. Press

the ENT key to confirm your selection.

5. Setting the alarm delay time in seconds: press the ▲ or ▼ key to set the alarm delay

time (setting range: 0 to 2000 seconds). Press the ENT key to confirm your setting.

Note: With this parameter you set the delay before the alarm relay activates when

the set point has been exceeded.