Instruction manual

Instruction Manual αlpha CON 2000
19
MEAS
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
SETUP
HOLD
HOLD
HOLD
HOLD
HOLD
HOLD
HOLD
HOLD
HOLD
HOLD
µS
4
4
4
4
4
4
4
4
4
4
4
4
°C
Temperature settings
see section 6.3
Relay A (set point 1) settings
see section 6.4
Relay B (set point 2) settings
see section 6.4
Controller settings
see section 6.5
Current output 1 settings
see section 6.6
Current output 2 settings
see section 6.7
Wash contact settings
see section 6.8
Unit settings
see section 6.10
Calibration
see section 5
ENT
ENTER
ENT
ENT
ENTERENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
ENT
CAL
SETUP
HOLD
4
Range settings
see section 6.9
ENT
6 SETUP MODE
6.1 Enter Setup mode
In the Setup mode the transmitter can be configured to your individual requirements.
1. While in Measurement mode press the ENT key.
2. The display prompts you to enter the security code. Set the security code
with ▲ or ▼ key to:
− “SCD 22” if you want to change parameter settings
− “SCD 000” if you want to view
only parameter settings (view
only mode)
3. Press the ENT key
Note: Note: to exit Setup mode at any time press the ▲ and ▼ key simultaneously
(escape). The transmitter returns to the Measurement mode.