User Guide

15
5.4.2 The Hi HYS Menu
1. Enter this menu by pressing the
MODE key to the “SEt” display
if you are in the measurement
mode.
2. Press ENTER key. If the
password has been set earlier,
key in the password using the
method described in section 4.1.
Press ENTER once to confirm.
After you set the correct
password, you see the “CAL”
and “COn” display blinks
alternatively. Press ▼ key thrice,
the display shows “Hi” “HYS”
blinking.
3. Press ENTER key to access the
Hi HYS menu and the display
shows the last Hi HYS value or
default (2% of Full Scale). Use
▲ and ▼ keys to change the
value of the Hi HYS point.
4. Press ENTER to confirm the
value of the Hi HYS.
5. Press MODE key to exit to
measurement mode. You can
press MODE key (as an
ESCAPE key) to revert to the
measurement value if ENTER is
not pressed; the set value is not
stored into memory.
SETUP
MODE
ENTE
R
Hi
SETUP
MODE
ENTE
R
02
SETUP
MODE
ENTE
R
HYS
NOTE : The
maximum value of
Hysteresis is 4% of its
Full Scale (FS)
selected. The HI HYS
hysteresis is spread
equally on either side
of the Hi SET point.