User Guide

13
ATC OFF : If a PT 100 is not used,
then the ATC should be set to OFF.
In step 3 above, choose by
pressing ▲ and ▼ keys to select
ATC OFF. Then press ENTER.
The display will now show the
default of 25
o
C or the last set value
(blinking). Use ▲ and ▼ keys to set
your desired value. Press ENTER
to confirm and the display shows
“CAL” “Con”.
Note : For ATC OFF, you can
adjust the set temperature values
from 0.0 to 99.9
o
C. This value will
be used for its temperature
compensation e.g. Conductivity in
the MTC mode.
SETUP
MODE
ENTE
R
A
tc
SETUP
MODE
ENTE
R
OFF
SETUP
MODE
ENTE
R
25.0