User`s manual

3.1 Wireless Client Bridge-to-Central Wireless Bridge

Figure 3-2

Refer to Figure 3-2 for the following setup.

Note: The UOW2000 Series AP is the Central Wireless Bridge and

UOW2000 Series CB is the Wireless Client Bridge

Step 1 Set the UOW2000 Series AP to perform a bridge (bridge IP

address: 192.168.1.1).

Step 2 Set Wireless parameters on the AP11 to: Channel (1) and SSID

(wireless)

Step 3 Set the UOW2000 Series CB to function in the bridge mode

(bridge IP address: 192.168.1.241).

Step 4 Set Wireless parameters on the UOW2000 Series CB to:

Channel (1) and SSID (wireless), and these parameters must be the

same with COU.

Step 5 Left side subnet is transparent to the right side.

Step 6 DHCP server assign IP address to PC1 and PC2