User`s manual

2.4 Basic Configuration
2.4.1 Basic Configuration Steps
This section describes a two-step
BASIC configuration procedure to
setup UOW2000 Series.
Step1 : Modify the factory-default parameters on the web page
“/BASIC/LAN/”, and click Save Settings to save the changes, than
click Continue .
Step2 : Modify the factory-default parameters on the web page
“/BASIC/Wireless/”, and click Save Settings to save the changes,
than click Reboot the Device to take effect on the previous
configuration changes.
2.4.2 Logging into the Web Interface
The UOW2000 Series supports access to the configuration system
through the use of an HTTP Interface.
► Web Configuration
Before configuring UOW2000 series, the user needs to know the IP
Address assigned to the unit. When shipped from the factory, the IP
Address 192.168.1.1 was assigned to the UOW2000 Series by default.
To start a web connection, use http://192.168.1.1
► Web Access Procedures
Once you identify the IP Address assigned to UOW2000 Series, use web
browser to configure UOW2000 SERIES through the HTTP Interface. The
following procedure explains how to configure each item.
Step1 : Open your browser and enter the IP Address
Step2 : Press <ENTER> key and the UOW2000 Series Login screen
appears as shown in Figure 2-5.
10