User`s manual
Enable Dynamic Mode Click the checkbox to enable Dynamic PPTP function.
IP Address If you select the PPTP support on WAN interface, fill in
the IP address for it.
Subnet Mask If you select the PPTP support on WAN interface, fill in
the subnet mask for it.
Server IP Address Enter the IP address of the PPTP Server.
Server Domain Name Input domain name to resolve DHCP server.
User Name If you select the PPTP support on WAN interface, fill in
the user name and password to login the PPTP server.
Password If you select the PPTP support on WAN interface, fill in
the user name and password to login the PPTP server.
Connection Type Select the connection type from pull-down menu. There
are Continuous, Connect on Demand and Manual three
types to select.
Continuous connection type means to setup the
connection through PPTP protocol whenever this
UGL2430-RTB is powered on.
Connect on Demand connection type means to setup the
connection through PPTP protocol whenever you send
the data packets out through the WAN interface; there are
a watchdog implemented to close the PPTP connection
while there are no data sent out longer than the idle time
set.
Manual connection type means to setup the connection
through the PPTP protocol by clicking the Connect
button manually, and clicking the Disconnect button
manually.
Idle Time If you select the PPTP and Connect on Demand
connection type, fill in the idle time for auto-disconnect
function. Value can be between 1 and 1000 minutes.
MTU Size Fill in the mtu size of MTU Size. The default value is
1460. Refer to 4.23 What is Maximum Transmission Unit
(MTU) Size?
Request MPPE
Encryption
Click the checkbox to enable request MPPE encryption.
Request MPPC Click the checkbox to enable request MPPC