User`s manual

31
hold the original conversation. When some one call in when you
are busy on another phone call , you will hear a du-du call waiting
signal, please use flash key on your phone to hold the original call
and answer the incoming call, press again flask key will switch
back the original call party.
 Disable: Disalbe the Call waiting function. The gateway will reply
the busy to remote side when the line is on used.
Index Area Code Auth Strip Prefix Maximum Minimum From To LineNo RS Verify CallWaiting Alert Profile Forward Delete
1 1
□ □
Rs1 Enable Delete
2 2
□ □
Rs Delete
3 3
□ □
rs3_2_1 Delete
l. Alert: Control the Ring Back tone generate timing:
 Mode 0: When this VoIP Router get ring back tone from phone line, it
will send the ring Alert signal to remote VoIP Router for generate ring
back tone.
 Mode 1: Before this VoIP Router dial to phone line, it will send the ring
Alert signal to remote VoIP Router for generate ring back tone.
 Mode 2: After this VoIP Router finish dial out number to phone line, it
will send Connect OK signal to remote VoIP Router.
 Mode 3: Before this VoIP Router dial to phone line, it will send the ring
Alert signal to remote VoIP Router for generate ring back tone, after
this VoIP Router finish dial out number to phone line, it will send
Connect OK signal to remote VoIP Router.
m. Profile: Define the optional special VoIP parameters when received on this
destination. Please input the name you defined on the profile list (/VoIP
Setup/Routing Setup/Routing Profile/).
Example: if user set the VoIP Call in & Routing Profile like below:
Index Area Code Strip Prefix Maximum Minimum From To LineNo Gatekeeper Alert Profile Forward Delete
1 1 PF1 Delete
2 2 PF2 Delete
3 3 Delete
Index Name VAD CODEC
H.245
Tunneling
DTMF
Relay
T.38
FAX Relay
Package
Frame
Q.931
Fast
Start
ID1 AS ID2 AS ID3 AS ID4 AS Delete