User manual

5
6. Installations & SIP Configurations
1. Connect UTG7100-IP RJ45 WAN port to NAT Router using a Category 5 LAN cable.
2. Connect RJ45 LAN port to Notebook PC using a Category 5 LAN cable.
3. Connect DC Power Adaptor. The LCD Panel will start displaying ”Loading Program” for about 5
seconds, and the LEDs will be ON and start initializations.
4. . The LCD panel will show Date, Time and No service without SIP registration, or <phone number>
after successful SIP registration.
5. Pick up the phone, and you will hear a dial tone and the LCD panel will show IP Dialing.. 1. If you
hear a busy tone, please check if the WAN port is connected and hang up.
6. Press Menu_7_4, and test (i.e. press 8 two times_3 three times_7 five times_8 two times_enter) to
enter password first. Press Menu_4_5 from keypad to read WAN and LAN IP addresses. The
default LAN IP address is 192.168.123.1.
7. Go to Chapter 8 and you may enter this IP address in IE Web browser for web configurations.
Configure and register UTG7100-IP into your SIP server. There are more details and examples
for VoIP application of SIP registrations in Chapter 10.
8. If UTG7100-IP has successfully registered in the SIP server, the LED REG will turn ON.
9. Pick up the phone, and press 123456# to call the party with the number 123456 registered in the
SIP server. Note that # will dial out the number immediately. Dialing without # will not dial out until
the auto dial timer (default=5 seconds) elapsed. In a moment, you should hear a ring back tone,
and wait for answer.
7. Default Reset by Using Keypads
Press Menu / 7.Administrator / 3.Default setting / 1.Load default by using Menu and arrow keys to
reset back to factory defaults, and the LCD panel will show Set Default…. In 5 seconds, the LCD will
start showing Loading Program and System Initialized. The UTG7100-IP will reset to default and
restart.
Press Menu / 7.Administrator / 7.Restart to reboot UTG7100-IP . In 5 seconds, the LCD will start
showing Loading Program and System Initialized.