Specifications

BIOS Setup
41
DPD5MAN101
8.2.4. Peripheral Configuration
Table 8. Peripheral Configuration Setting
Setting
Contents
Spread Spectrum Clock
Enable Spread Spectrum Clock.
・Disabled(Default) - disable
・Enabled - enable
8.2.5. HDD Configuration
Table 9. HDD Configuration Setting
Setting
Contents
SATA Device
Set SATA device.
・Disabled - disable
・Enabled(Default) - enable
Interface Combination
*13
Set operating mode of SATA controller.
・IDE
・AHCI(Default)
・RAID
Serial ATA port X
*13
Show Device ID connected to Port X. When device is not
connected, a message “Not Install” is displayed.
Hot Plug
*13
Enable hot plug.
Note: Hardware support required
・Disabled(Default) - disable
・Enabled – enable
External Port
*13
Set port as internal or external.
・Disabled(Default) - disable
・Enabled - enable
Port Topology
*13
Set connection mode of SATA 6Gb/s port. Only port 0and port
1 support SATA 6Gb/s.
・DirectConnect
・CableUp(Default)
SATA Device Type
*13
Solid State Drive should be selected only when SSD is
connected to SATA port.
・Hard Disk Drive (Default)
・Solid State Drive
*13: possible to set by changing SATA Device to “Enable”