Datasheet
CPU-1450 Power management connections 18
Auxiliary Power Connector
The CPU-1450 connector J9 is a 12-Pin (6x2) 2.54mm pitch connector and is used to power the module as
an alternative to the PC/104-Plus bus, this connector also carries signals for power management
Auxiliary
Power
J9
Figure 5. J9 Connector layout
Pin # Signal Pin # Signal
1 GND 2 VDD
3 N.C. 4 +12v
5 -5V
6 -12V
7 GND 8 VDD
9 N.C. 10 PWRBTN# (3)
11 +5VSB (1) 12 PSON# (2)
(1)
+5VSB: +5 Volts-Always from the ATX Power supply
(2)
PSON#: Power-On command to ATX Power supply
(3)
PWRBTN or Power button :If the soft power management is enabled, a low signal in this pin turns the
system on or off.
Notes:
The +5VSB (Volt Stand-By) voltage is useful for Power management applications only.
The +12VDC and -5VDC voltages are neither used nor generated by the CPU-1450
module: they are only conveyed on the PC/104-Plus bus (connector J1) and can be
used by other devices or modules that are stacked onto the CPU module.
Warning:
Improper connection of the power supply will result in serious damage to the module.
An0065. CPU-1450 Soft Power Management