User's Manual

DynaGATE 10-12 User manual Rev. 2-1 16 How to install the product
16 HOW TO INSTALL THE PRODUCT
The product is intended for professional use and must be installed by qualified personnel only.
The product must be installed in a secured location, accessible to authorized personnel only (for
example in a cabinet / technical compartment).
16.1 How to install the product
To install the product in place, complete the following steps:
1. See "Mechanical specifications" on page97
2. Use the 4 slots available on the Mounting Bracket
3. Add all the necessary mounting hardware to safely fasten the DynaGATE 10-12 in place according
to your installation requirements (for example use 4x M5 screws, with a minimum length of 15 mm).
Material, type, and length of the screws, and the maximum torque applicable, depend on
your installation requirements.
The integrated Mounting Bracket is made of 2 mm aluminum alloy 5052.
In case of uncertainties contact the Eurotech Technical Support Team (see "How to receive
technical assistance" on page15).
99 / 114