User's Manual

DynaGATE 10-12 User manual Rev. 2-1 17 Power supply. How to turn ON/OFF and reset the product
7. Connect Pin 3 (Key Signal) to "Power IN +".
The DynaGATE 10-12 automatically turns ON and the LED 6 (POWER) turns ON
NOTICE
When connecting Pin 3 to "Power IN +", keep it connected for at least 10 seconds.
If you disconnect "Power VIN +" from the Pin 3 before 10 seconds have passed, the start-
up procedure will not be completed correctly and an immediate and unsafe power down
will occur.
8. To keep the DynaGATE 10-12 turned ON, make sure that Pin 3 keeps connected to "Power VIN +".
17.3.1 Note about the Vehicle Ignition Sense
The Vehicle Ignition Sense is a digital input that can be used to read the status of Pin 3 (Key Signal).
For more information see: "How to read the Vehicle Ignition Sense status" on page88.
17.4 How to turn OFF the product
To turn the DynaGATE 10-12 OFF follow these steps:
1. Disconnect the KEY pin from Power IN +. The DynaGATE 10-12 performs a safe shut down
2. Remove the power from the Power IN connector.
17.5 How to reduce the power consumption of the product
To reduce the power consumption of the DynaGATE 10-12, turn OFF the radio interfaces and disable
unnecessary services that contribute to overall system power consumption.
17.6 How to hardware reset the product
To trigger a hardware reset of the DynaGATE 10-12, push the hardware reset pushbutton available in the
Service Panel.
103 / 114