User's Manual

ReliaGATE 10-12 User manual Rev. 2-1 9 Interfaces in detail
9.2.4 The MicroSIM card holders
The ReliaGATE 10-12 includes the following MicroSIM card holders:
l 1st MicroSIM card holder: l Integrated in a Combo MicroSD (push-pull) + MicroSIM
(pull-lever) cards holder
l Placed on the top side of the circuit board in the Service
Panel
l 2nd MicroSIM card holder: l Push-pull card holder
l Placed on the bottom side of the circuit board in the
Service Panel
If you use a single SIM card, use the 1st MicroSIM card holder.
Turn OFF the SIM PIN before inserting the SIM card in the holder.
The cellular connection will not work if the SIMPIN is ON.
9.2.4.1 How to insert / remove the MicroSIM card
If you are using the holder on the top side of the circuit board
To insert the MicroSIM card, complete the following steps:
1. Orient the MicroSIM card with the contacts facing the circuit board and the cut corner - highlighted
with the letter A - facing the holder
2. Push the MicroSIM card in the holder
To remove the MicroSIM card, pull the eject lever: use a pen tip to simplify the operation:
51 / 118