User's Manual

ReliaGATE 10-12 User manual Rev. 2-1 Appendix 1: Advanced boot options
To configure the system in Linux, insert the following commands:
fw_setenv fitboot ‘setenv image_path $fit_path; run imageload; bootm ${loadaddr}:kernel@1 -
${loadaddr}:fdt@reliagate-10-12-<variant>.dtb;
where <variant> is either: xx, spi or gpio.
To configure the system in the bootloader, insert the following commands:
setenv fitboot ‘setenv image_path $fit_path; run imageload; bootm ${loadaddr}:kernel@1 -
${loadaddr}:fdt@reliagate-10-12-<variant>.dtb;
where <variant> is either: xx, spi or gpio.
113 / 118