User`s manual

DuraMAR 2150 – User’s Manual

The commands are represented by the text of the SMS message. Available commands:

SERCPU

Connects the GPRS modem serial interface to ECC ttyS1

interface

Connects the GPRS modem serial interface to the AUX port of the

CISCO 3200 ISR

SERCISCO

Force a hardware reset of ECC.

RESETCPU

Force a complete system reset with power-off/power-on cycling.

RESETALL

When a new SMS message is received, the subscriber number is checked against the available entries in

the phonebook and the command is executed only if the number is verified.

Phonebook entries can be managed from ECC CLI using the

set phone-book command.

The complete syntax of the command is:

set phone-book <item> <number>

item

identifies the entry and must be a number between 1 and 4

number

is the authorized subscriber number and must include the international prefix (es. +39)

An item can be removed from the phonebook using the no-form of the command. For example the following

command will remove the item at position 2:

no set phone-book 2

In order for the changes to be written to the GPRS modem you must issue a copy running command,

otherwise any change will be lost after a system restart.

During the execution of this command, the gprs0 interface must be disabled, otherwise the modem phone-

book can't be updated because the interface is in use by the ECC controller.

In case you are using a startup configuration with gprs0 interface enabled you must:

1. disable the gprs0 interface first

2. apply changes to the phone-book entries

3. save the running configuration using the copy running command

4. enable the gprs0 interface

5. issue a copy running command again

In this case there is no need for accessing the GPRS serial interface during the execution of the copy

running command because the phone-book is unchanged.

Since the phone-book is loaded from the modem only when system is powered-on, after any change to the

phone-book entries the system must be switched off and then switched on again in order for the changes to

take effect.

Note:

Wait for about 30 seconds before switching on again