User`s manual

Am186™CC Microcontroller Router Reference Design User’s Manual
1-4
Connecting to a PC Via a USB port
To connect the Am186CC microcontroller router reference design to your PC’s
USB port:
1. Insert the flat end of your USB cable into the USB port on your PC.
2. Connect the other end of the USB cable into the Am186CC microcontroller
router reference design’s USB connector (see P9 at J-1 in Figure 2-1 on page
2-3) that is located near the corner of the board and is labeled “USB”.
3. Download the USB CodeKit software from the AMD website. Go to
www.amd.com and click on Embedded Processors to get to the USB CodeKit
software packages used in the Am186CC microcontroller router reference
design. Each CodeKit software package includes installation instructions in a
README.TXT file. Download these three CodeKit packages:
– Am186CC Communications Controller USB Driver CodeKit Software
Package
– Am186CC Communications Controller USB-UART Driver CodeKit
Software Package
– Am186CC/CU Microcontroller USB Port Expander CodeKit Software
Package
NOTE: In addition to the three CodeKit packages, you also need to download
the Expose-USB Diagnostic Tool from the same site.
about.book Page 4 Wednesday, July 21, 1999 11:10 AM