User guide

Menu options
3GS User Guide
7
User Guide
Menu options
The system is programmed using the Help menu options:
In sequence, as a Master User you can use these menus to :
l Disarm the system and reset all warning devices
l Remove system display messages and silence the buzzer
l Part set the system
l Half set the system
l Full set the system
l Reset the system following an alarm
l Set the system date and time
l Change existing user codes
l Set up new users
l Set up a new area system
l View system log
l Adjust the system for summer / winter hour change (Daylight
Saving Time)
l Isolate a troublesome zone that is preventing the system from arming
✍ The advanced options Radio PA Assign, Radio PA Test,
Setup Cards, Card Information, and Manual Door
Control are described elsewhere in the 3GS
Programming and System Integration manuals. See
your installer for details.
All of these options are accessed by pressing the CODE followed by
the HELP key.
By default, the MASTER USER CODE is 1020. The system installer
may have configured your own unique CODE, in which case this
should be entered instead of the default (1020) code.
An option is selected by pressing the YES key .
Use the UNSET key to move to the next option
Use the PART key to move back
To exit without selecting an option, use the NO key
✍ Only options which have been assigned to a user are displayed.
The Master user will have all options.
The hash button acts as an ENTER key for the keypad.
Once the help routine is entered a selection must be made within 90 seconds, otherwise the system will exit
from this menu.
✍ It is advisable to assign only the minimum number of system options to general users,
to facilitate ease of use of the system.