User guide

Coded Reset
16 3GS User Guide
Coded Reset
Under normal conditions, the system can only be re-armed after an alarm activation by a service/installation
company visit.
The display will show a CALL SERVICE message and the user will not be able to re-arm the system.
When enabled, the Coded Reset option allows you to re-arm the system, avoiding the need to call an
installer to the site.
When you have acknowledged an alarm, the keypad will continue to display the message:
If you attempt to re-arm the system, the keypad will beep, and then briefly display the message:
You should now contact the Security Control Station for a release code. If the Security Control Station is
unable to give you a release code, contact your installer.
User Reset Procedure
Select Coded Reset.
The display will show a random 4-digit number.
Contact the Control Security Station with this random number.
The Central Station operator then converts this number to a 4-digit return
code acceptable to the system.
When you receive your return code from the Central Station operator, return to the keypad, and press the
key.
The display will prompt you to enter the return code:
Key it in at the prompt. If the code is incorrect, the display will show:
When you have keyed in the correct code, the display will show:
You can now re-arm the system by selecting Full Set (see page 13).
✍ All users who have the FULL SET option will automatically be assigned the Coded Reset
option. See User Setup on page 19.