User guide

Part Set
3GS User Guide
11
User Guide
Part Set
Your system will be set up as either:
l standard alarm with one alarm area,
l or 8-area, with 8 separate alarm areas within one
system.
A standard alarm system is set using the Part, Half, and
Full procedures.
The Part and Half options are disabled for the 8-Area
system. Instead, the different areas within the system are
set and unset independently of each other, as described
on page 15.
Part Set
With a standard alarm system, you can isolate particular
areas of the premises and set these areas independently of
the rest of the system.
Part Set allows you to protect the perimeter of a premises
while allowing free movement through the exit and access
area (e.g. from door, hall).
This would typically apply to the day or evening operation of the system when people are on the premises
and using the common exit. There is free access to the areas being used while the rest of the building is
armed.
There are no entry or exit times associated with this mode and protection is applied instantly.
The display remains blank and will only change to show alert and warning messages.
If selected while entering the building while the entry timer is running, the entry mode is cancelled and the
buzzer is silenced.
l If selected by mistake refer to “Unset/Reset” on page 9.
l If unable to set refer to “Unable to Set” on page 14.
✍ Please ensure that you have been properly instructed in the setting and unsetting of your
system.