Installation guide

NOTES CONCERNING THE MODEL 1431/32 AUTO-DIAL MODEMS cont.

For example: Suppose that only read commands (read zone states, read output states) and write

commands (set IDs, options, time, etc.) are to be allowed when the panel is in the DISARM

mode. Then set the access control to 24 (8 + 16). Press the RETURN/ENTER key to proceed.

The display will now show LOG FILTER 8191. All data reported to a central/monitoring

station, either on the DVACS

network or through the autodial modem, is obtained from the

panel log that contains a record of all activity. The log filter provides a means of filtering this

data such that only the required data is reported. The panel defaults to reporting all logged data.

The log filter can be set to meet the installation requirements by adding up the values, shown in

the right-hand column in the table below, of the various data types that are to be reported.

LOG DATA TYPE SELECT

1 - Zone activations 1

2 - Status alert messages 2

3 - User actions 4

4 - Output switching 8

5 - Variable values 16

6 - Single-byte variable 32

7 - User-defined message format 64

8 - Date change (never reported) N/A

9 - Not used 256

10 - Zone shunting 512

11 - Zone unshunting 1024

12 - Zone disabling 2048

13-15 - Not used 4096

Total 8191

For example: If only zone activations are to be reported, set the log filter to 1. If zone activations

and user actions are required, set the log filter to 5 (1 + 4). The default value is all choices, 8191.

Enter the new value or press the RETURN/ENTER key to proceed. Warning: If an even

number is entered, no zone alarms will be transmitted!

The display will now show DIAL MODE 0. When the autodial modem is connected, set the

dial mode to 1 or 3. Enter the appropriate value as determined from the following list and press

the RETURN/ENTER key to proceed.

0 - No autodial modem connected.

1 - A logging printer is connected to an autodial modem at the remote location. When any

event is logged by the panel, but not filtered by the log filter, the remote location will be dialled