Installation guide

In addition, when an individual area is disarmed, the common area is disarmed automatically and

the armed output C-LEMs (if used) for both that area and the common area are reset.

INTRUDER ALARM

When an intrusion occurs on an instant-acting zone, then INTRUSION panel relay output 1 and

output C-LEM 1, INTERNAL BELL output C-LEM 10, TIMED BELL panel relay output 7 and

output C-LEM 7, and the individual AREA ALARM output C-LEM will operate. The display

will show the flashing alert message ** INTRUDER ALARM **, alternating with a flashing

zone description of the first zone to trip. If the intrusion involves an timed exit/entry door, then

at the expiry of the exit time the flashing alert message *SLOW ENTRY ALARM* (see below)

will be displayed, along with the previous alert message and zone description. If the intruder

ventures into other areas, then the first zone to trip in each new area will also be displayed. At

the end of the bell cut-off time, all panel relays and C-LEMs except C-LEM 10 will be reset. The

outputs can also be cancelled by disarming an area. If this is done, all panel outputs will be

turned off and the individual AREA ALARM output C-LEM for that area will also be turned off.

Individual output C-LEMs for the other areas are not affected.

SLOW ENTRY ALARM FEATURE - When an area is armed, entry through an EXIT zone

will cause the piezo-sounder to start beeping for the amount of time set in the Exit Time variable

(see page 48). This is to remind the user to disarm the panel. If the user waits too long, the entry

time will expire and a full intruder alarm will occur. The display will show the flashing alert

message *SLOW ENTRY ALARM*, alternating with a flashing alert message and zone

description.

ACKNOWLEDGING ALARMS

Whenever the piezo-sounder is beeping and a flashing message appears on the display (e.g.,

** FIRE ALARM ** or ** INTRUDER ALARM **, these can be cleared by acknowledging

the alarm. To do this, enter your user code and then press the 0 (zero) key. The panel will

momentarily show CLEAR DISPLAY and then return to date and time.

RESETTING OUTPUTS

Whenever an alarm condition results in a panel relay or C-LEM being operated, selected outputs

can be turned off by acknowledging alarms (see above) or by fully disarming the panel. To fully

disarm the panel, enter your user code and then press the FULL DISARM key. In addition, selected

users can also use the AUDIBLE SILENCE 1 or 2 key to turn off panel outputs. Enter your user

code and then press either the AUDIBLE SILENCE 1 or the AUDIBLE SILENCE 2 key.

OPERATING THE PANEL cont.