Installation guide

PROGRAMMING THE PANEL cont.

changed by pressing the YES key. Use the FULL DISARM (+) key to advance to the next output

and the AUDIBLE SILENCE 1 (-) key to back up to the previous output. Press the NO key to

quit. The outputs will remain as set. To reset any changed outputs to their normal state, you must

disarm the panel.

PRINT REPORTS (P key): This function allows all system reports to be printed. The following

reports are available:

1. SYSTEM VARIABLES 4. ON-LINE REPORT

2. USER NAMES AND OPTIONS 5. SYSTEM LOG

3. CHANGED LITERALS

Enter the Service user code and then press the P key (shift 6). The display will show PRINT

ALL REPORTS ?. Press the YES key to print all the reports or press the NO key to exit. If the

YES key is pressed, reports 1, 2, and 3 will be printed. The display will show PRINTING

VARIABLES. After the variables have been printed, the display will show PRINT USER IDS

?. If the YES key is pressed, the display will show ENTER CODE _ _ _ _ _. If you wish the

user list to include all user codes, then enter the Master user's code and press the RETURN key.

If no code or the wrong Master user’s code is entered, then the list will not contain the user

codes. The panel will then prompt the user with PRINT ON-L REPORT ?. Press any key to

proceed. The panel will print the on-line report and then the system log. Press the NO key to

abort these at any time. Note: this option is not available with DVACS

(tm)

unless the Model

3302R3 port splitter is installed as part of the system.

RESTART SYSTEM/SOFT START (R key): This function is used to restart the panel without

having to open the cabinet door and press the CPU reset button. This capability is essential if the

serviceperson is changing the LEM count and requires a re-initialization of the LEM line. Enter

the Service user code and then press the R key (shift 7). All outputs will immediately be reset

and the usual start-up messages will be displayed. When the display shows INITIALIZE LEM

LINE?, press the YES key. The display will show ON-LINE O-->N, where O is the old zone

count and N is the new zone count. From this moment on, the procedure is the same as for

LEM-LINE INITIALIZATION (see page 35).

SET DATA FORMAT (S key): This function allows the panel communications to be

configured for connection to a number of devices including a printer, an auto-dial modem, a

computer, and the DVACS

(tm)

network. Enter the Service user code and then press the S key

(shift 8). There are many options to be chosen; the actual options presented will depend on the

device being configured. Some options require a yes or no selection (e.g., TRANSMIT NAME

YES, where the flashing YES indicates the current setting). Others will require a numeric entry.

PROGRAMMING THE PANEL cont.