Installation guide

PROGRAMMING THE PANEL cont.

SYSTEM VARIABLES RECHECK:

When the SUPVRY SHUTDOWN 0 variable is displayed, press the AUDIBLE SILENCE 1 (-)

key to check the variables. This will start a reverse scroll through the list. When the entire list has

been checked, press the NO key and the display will show QUIT ?. Press the YES key to exit or the

NO key to return to the flashing sub-menu.

LITERAL EDIT (E key): This mode is used by the serviceperson to modify text phrases,

command strings, zone responses, etc. For example, to change the designation of an area in the

multi-area system to something more descriptive (e.g., AREA-1 to OFFICE, AREA-2 to SHOP,

etc.), you may edit literals 150 through 158. To select this mode, enter the Service user code and

then press the E key (shift AUDIBLE SILENCE 2). The display will show ENTER LITERAL

NO. 1. Enter the relevant literal number and press the RETURN key. The display will show the

flashing sub-menu EDIT---COPY--DEFAULT. Press the FULL DISARM key to select EDIT,

delete the current entry (e.g., AREA-1), and enter the new area name (e.g., OFFICE). Press the

RETURN key to complete the entry. See page 4 for information on entering names and numbers.

DISABLE MODE (F key): This mode is used by the serviceperson to disable zones. The

results are similar to those arising from the SINGLE-ZONE SHUNT function (see page 42); the

main difference is that disabled inputs are treated as if they were no longer on line (i.e., no

change of any state is reported). To select DISABLE mode, enter the Service user code and

then press the F key (shift FULL ARM). If some zones are already disabled, the message

CLEAR ALL DISABLES ? will appear. Respond by pressing either the YES or NO key.

Pressing the YES key will remove all disables, whereas pressing the NO key will leave the

disables in place. Both selections will cause the display to show DISABLE FROM 1. Press the

NO key to exit or proceed with the rest of this section to disable more zones. Enter the first zone

number to be disabled and then press the RETURN key. The display now will show DISABLE

TO #. Enter the last zone number to be disabled, which may be the same as the first, and then

press the RETURN key. The panel display will show N DISABLES, where N is the number of

zones disabled. Exit is automatic. Disabled zones are not cleared on entry to the DISARM mode

but the number of disables, if any, is displayed each time any arming or disarming mode is

entered.

DAYLIGHT SAVING TIME CHANGE (H key): Any time during the week that the Daylight

Saving Time change occurs, enter your user code and then press the H key (shift HELP). When

this mode is selected, the display will continuously show HOUR CHNGE ON SUNDAY and

the time will advance or retard by one hour at 2 a.m. on the following Sunday morning. The

panel will figure out whether to advance or retard the hour by looking at the current month. The

hour change may be cancelled by reselecting this mode. Once selected, the message HOUR

CHNGE ON SUNDAY will be automatically cleared when the hour change takes place. If this

mode is entered in error, re-enter your user code and press the H key. The display will show

CANCEL HOUR CHANGE for a moment and the message will be removed.