Installation guide

47
allow this general user to disarm the panel, press the RETURN key. The flashing NO will
remain and the next option will follow. If this option is to be allowed, then press the YES key.
This changes the NO to a YES on the panel to confirm your choice. The next option will then
appear, along with NO. This procedure must be repeated for this user for all 10 options listed
below. The AUDIBLE SILENCE 1 (-) key may be used to return to a previous option. Hint: If
you are only changing a few options, you may wish to exit before all 10 options have been
displayed. Press the HELP key and the next user will appear. To exit from this option, press the
NO key whenever the display shows ENTER USER NO. #. The display will now show QUIT
? and you may press the YES key to exit or any other key to return to the sub-menu.
The following is a list of all possible options presented to the Master user, user number 2:
DISARM FULL ARM SINGLE ZONE SHUNT SET IDS/OPTIONS
AUDIBLE SILENCE 1 CLEAR DISPLAY SET DATE/TIME
AUDIBLE SILENCE 2 SYSTEM LOG 9 KEY
If the Service user, user number 1 is at the keyboard and has entered his or her user code and
selected SET IDS/OPTIONS, the procedure for assigning identification codes is the same as
above; however, in the OPTIONS option, a different list is presented.
DISARM SYSTEM LOG ASSIGN ZONES/VARS LITERAL EDIT
FULL ARM SINGLE-ZONE SHUNT SET IDS/OPTIONS
CLEAR DISPLAY SET DATE/TIME SERVICE MODE
NAMES - To select NAMES, press the HELP key. The display will show ENTER USER
NO. 1. If user number 1 is to be chosen, press the RETURN key. If a user other than number 1
is to be chosen, enter his or her number and then press the RETURN key. The display will show
L a flashing cursor, /\, in the farthest-left position. Enter a user’s name up to a maximum of 11
characters. (See page 4 for information on how to select the letters of the alphabet.) When the
entry is complete, make sure that the cursor is at normal shift (up) and then press the RETURN
key. The display will now show the next user number. If this user’s name is to be entered, press
the RETURN key and follow the procedure described above. To exit, press the NO key when the
display shows ENTER USER NO. #. The QUIT ? message will then appear and you may
press the YES key to exit or any other key to return to the flashing sub-menu.
ASSIGN ZONES/VARIABLES (D key): This function is used to enter the actual location of
each zone or a description associated with it (e.g., 1. FRONT DOOR, 6. FACTORY PASSIVE,
etc.). To select this function, enter the Service user code and then press the D key (shift
AUDIBLE SILENCE 1).The panel will display a flashing sub-menu: DESCS---TYPES--VARS.
PROGRAMMING THE PANEL cont.
ZONE DESCRIPTIONS - To select ZONE DESCRIPTIONS, press the FULL DISARM key.
The panel will display ENTER ZONE NO. 1. If this is the desired zone, then press the