Installation guide

46
IDS (IDENTIFICATION CODES) - To select or change identification codes (IDS), press the
FULL DISARM key. The panel will display ENTER USER NO. 1. If user number 1 is to be
chosen, press the RETURN key. If a user other than number 1 is to be chosen, enter his or her
number and then press the RETURN key. The next message displayed will be ENTER CODE _
_ _ _ _. User codes can have four or five digits. The five-digit code capability must be enabled
by the installer during the powering-up sequence (see page 36). Otherwise, the control panel will
default to the four-digit capacity. Four-digit codes are acceptable if the five-digit option has been
chosen but, in this case only, the RETURN key must be pressed to complete the entry. If you
L have elected to use four-digit codes, enter any numeric code from 1000 up to 9999. (Note that,
unlike in the previous software, numeric codes 1 to 0999 are not allowed. This is because the
new Duress alarm feature described on page 67 uses a lead 0 numbering scheme.) If you have
elected to use five-digit codes, enter any numeric code from 1000 to 32767 but remember that
four-digit codes with a five-digit option will require the use of the RETURN key. As a security
feature, user codes are never displayed as they are entered because they may be seen by others
near the panel or at a remote keypad. Instead, a * will be displayed for every digit entered. After
a code is assigned, you must press the RETURN key to advance to the next user number. If this
user requires a code, then press the RETURN key and follow the procedure described above.
Note: No two user codes can be the same!! The panel will test for duplicate codes. If one is
entered, the piezo-sounder will beep and the display will show USER # DUPLICATE. To exit,
press the NO key when the display shows ENTER USER NO. #. The QUIT ? message will
appear and you may press the YES key to exit or any other key to return to the sub-menu.
L REMOVING A USER CODE: Select IDs as above, enter the user number in question, press
the RETURN key, enter a single * (AUDIBLE SILENCE 2) for the code, and then press the
RETURN key again. This will delete the old code. Press the NO key to quit and the YES key to
exit. On a remote keypad press the PART ARM 2 button, not the * button beside the 0 button.
RESETTING USER 1 AND 2 IDS: If through the course of staff changes, etc., the Service
user’s code or the Master user’s code has been lost, then these two user codes only may be reset
to the factory default value (i.e., Service user 1 will again have code 1010 and Master user 2 will
again have code 1020). New codes may then be assigned. All other user codes will remain
unchanged!
To perform this reset procedure, open the panel door and press the CPU reset button to the left of
the display. Quickly close the door and press the AUDIBLE SILENCE 2 key when the display
shows A100 8A250U 3NOV98. The piezo-sounder will beep and the display will show RESET
USER 1&2 IDS ?. Press the YES key to reset the Service user's code to 1010 and the Master
user's code to 1020 or the NO key to leave them unchanged.
OPTIONS - To select OPTIONS, press the AUDIBLE SILENCE 2 key. The panel will display
ENTER USER NO. 1. Enter the number of the user to whom you wish to assign the options
PROGRAMMING THE PANEL cont.
and press the RETURN key. The panel will now display DISARM NO. If you do not wish to